Routing

Hi Netprowhicj of the below line the router process first?pls a bit explanationip route 1.2.3.4 255.255.255.255 4.4.4.4ip route 1.2.3.0 255.255.255.0 4.4.4.4.4thanks

Hi NetproPls can y expert help me to Maintain and administer asr 2 asr routers connected to two different isps , so that no no impact for business in term of reliabilty  and performancethanks

I have a question, it is possible to have two WAN interfaces to configure a cisco 892 routerwith an ip 255.255.240.0 84.197.167.111 adderess of the first interface and a different ip address 84.197.174.182 255.255.240.0 on the second interface

Hi Guys,Im having a little trouble with a router I have got my hands on to practice for my CCNA.Im connected via serial>USB adapter and via XP HT on Win7.Router boots and I then break the boot sequence with ctrl-break. But then it does not go into RO...

Hi,I have a ASR 1004 with the following int:1 x Cisco 8-Port   Gigabit Ethernet Shared Port Adapter2 x Cisco 1-Port 10GE LAN-PHY Shared Port Adapter1. Can I do a backup int in 1 of the 8 Port gigabit ethernet port to backup another port in the same m...

Dear AllI know who can help me to configure my cisco 892 routerwant a static ip address assigned to the interface becauseand I have no more internet on the routerbecause am working on my network academy for CCENT Please help!

No idea if this is the place to ask, but I cannot figure this out. Got 3 3750's, and a bunch of ME3400 switches. One of the 3750 runs a dhcp server, but the problem is, I keep seeing that it's very, very hard for clients to actually get an IP. Someti...

Hi!I have a customer that is running a 2911 with a VWIC2-2MFT-T1/E1 card. This is going to be connected to a ISDN E1 PRI from the public operator. The output from the PRI box is 120ohm. My question is can I use a standard Cat5e cable for this connect...

HiI need to configure a Cisco 877 router like a bridge. I have a firewall SA520 before the cisco 877.I need to configure the public IP on the interface WAN on the firewall, and I can´t configure any NAT on the router.I try to configure the cisco 877 ...

Hi. I have two Cat6506 (redundant collapsed-core config) configured  w/  RPVST+ and connected to this are a series of Cat2950s configured  with  PVST.  My question is, is this a good practice configuration of  STP? If not whats the best practise .Wha...

web have a cisco 3825 router with two gigabit ethernet ports and a SFP port at same timecan i make use of two ports or only one(SFP or Gig0/0) port

Hi Community,Scenario: HQ WAN Router already has a QoS Policy applied on its WAN port (30M link) [HQ has several branch sites and no issues with the rest of them except one branch. That one branch will be spoken about in this thread]Branch WAN Router...

Hello Everybody,I have a special Network Architecture , where i have a stable and realiable wirless Network That works in Layer2 and this is my main Network to connect my remote location to the Hub, and at the same time i have an IP VPN over MPLS Net...