Solved: Cisco 2500 series router reset to factory default?

jsantana5 · ‎12-03-2014

My router was configured by another guy and now is locked on this position (Cisco Controller)> can someone tell me how to reset it to factory defaults?

paul driver · ‎12-11-2014

Hello you can perform a passwory on it and the. erase the config

http://www.cisco.com/c/en/us/support/docs/routers/2500-series-routers/12722-pswdrec-2500.html

res

paul

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

View solution in original post

paul driver · ‎12-11-2014

Hello you can perform a passwory on it and the. erase the config

http://www.cisco.com/c/en/us/support/docs/routers/2500-series-routers/12722-pswdrec-2500.html

res

paul

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

jsantana5 · ‎12-11-2014

Thank you all for your help, I was able to performed a password recovery and re-configure the router thanks a million