Cisco 2610 does not work with AIM-VOICE-30 ???

[knoplya80]

I have tried to install the following configuration Cisco 2610 + VWIC-1MFT-E1 + AIM-VOICE-30.

On www.cisco.com it is specified, that AIM-VOICE-30 works with 2610 router, but I have already tested it with two different Cisco 2610 routers. AIM-VOICE-30 does not up in any way (i have tried all possible IOS es). I has put AIM-VOICE-30 on 2651 and it has working without problems. Have you information AIM-VOICE-30 works with 2610-th (not XM) or not???

[lgijssel]

According to the datasheet it should work indeed. The 2610 has only one AIM slot, no misstake possible there. So I assume that it is the IOS. This URL describes the minimum requirements:

http://www.cisco.com/en/US/products/hw/modules/ps3115/products_data_sheet09186a0080088753.html#wp40023

Suggest that you try with exactly these releases.

Regards,

Leo

[thisisshanky]

Can you paste a sh version out of the router ?

[knoplya80]

I have read this document very carefully many times.

12.2.8T release not exist on www.cisco.com.

I have tried many releases of 12.2.15T and 12.3.15 and nothing.

Have you any other opinions?

[lgijssel]

Didn't find 12.2.8T either but Cisco has made it simpler by removing some images from CCO. I must admit that I found the previous system far out preferrable but ok. You should check the software migration table at:

http://www.cisco.com/en/US/customer/products/sw/iosswrel/ps5187/prod_bulletin0900aecd80281c0e.html

I had a quick look for you already.

The other refererenced release is 12.2.2-XB.

Release 12.2.2-XB has been replaced by 12.3.5e by which is suggested to use 12.3.5f, so I suggest that you try that one.

Just for the laugh: The changes are documented in a pdf called: SIMPLIFICATION.pdf Someone at Cisco must have at least some sense of humour.

Regards,

Leo