Routing

I have implemented a network where 2 sites are connected through 1 router 3660 on each by 2 mbps leased line. Pix 515 firewall is placed at LAN on both ends. Intervlan routing is done by PIX. Pix inside, outside & router Ethernet interfaces is gettin...

Dear All, I am still new to the world of Cisco. I have here in My Network one Core Switch 4506 with 15 Edge Switch 3560. We configure the Core Switch with This Command :- A- ) HO-CSW-01(config)#username design privilege 15 password kabdesign B- ) HO-...

Hello,I got a problem with a Cisco 2600. This router has 2 WAN interfaces. 1 serial for leased line connection and 1 BRi for ISDN backup.When the main link is down the bri automatically connects to another router a cisco 3640.when the isdn link is es...

It read somewhere on Cisco.com that if I run this command ''clear interface FastEthernet0'' , the config on the interface will get removed. I did it on 1721 but , the config is still there on fastEth....Can anybody explain

I'm using a 1711 router. After setting it up, I got complaints from my users that they cant access the inbox of their web-based emails. An example is Yahoo and Hotmail. They can login to their account but when the click the inbox, they get an error a...

I am trying to configure QoS on the above routers and since they do not have AutoQoS I am doing a map-class frame-relay but the link becomes inaccessible after about 2 minutes. I am using the following configuration syntax below:ip rtp header-compres...

Hii have isdn backup link leased line and i use route-map policy to route packet out. when link leased line down , isdn will connect to backup but in truth when my leased line down (line protocol down) isdn backup not call connect . i try to do every...

Hi, Can someone advise me on which additional module I should purchase to have additional FE ports on top of the 2 ports that comes with the 2801 router. Thanks!Dan

Hello Can someone please point me to documentation implementing multicast over a wan linkTIAShervan

Hello All,Do any of you have some clear directions on how to enable intervlan routing for the Catalyst 4500 Series? I have a very simple network, and need to vlan it.Here is the basic layout:Internet--Firewall(non cisco)--Catalyst 4506I have my two ...

I was reading up on eigrp, it says that its uses bandwidth and delay, I thought it used hop count also ?also what is the delay, is this lower on certain types of interface i.e via ethernet or serial ?thanksCarl