cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
677
Views
0
Helpful
1
Replies

Cisco 2651XM - Adding a new FE interface?

gil.juguilon
Level 1
Level 1

Hi,

I have a Cisco 2651XM router with two built in FE interfaces. Please, I just wanted to know if I could add another FE interface.

Listed below if the router details:

cisco 2651XM (MPC860P) processor (revision 0x200) with 125952K/5120K bytes of memory.
Processor board ID JAE080500QG (624065010)
M860 processor: part number 5, mask 2
Bridging software.
X.25 software, Version 3.0.0.
2 FastEthernet/IEEE 802.3 interface(s)
2 Serial(sync/async) network interface(s)
32K bytes of non-volatile configuration memory.
32768K bytes of processor board System flash (Read/Write)

Hoping for your response.

Thanks!

Gil

1 Reply 1

Reza Sharifi
Hall of Fame
Hall of Fame

Hi Gil,

Yes, there is space to add a network module interface to your 2651XM. That will give you an aditional 10/100 port.

http://www.cisco.com/en/US/docs/routers/access/2600/hardware/installation/guide/2600ch1.html

HTH

Reza