Cisco 2801 and VIC2-2E/M Card Problem

[hardik_tankaria]

Hi Experts,

One problem with my cisco 2801, when I have inserted the E&M card it is not supporting on the slot. The output of show diag is as attahced.

IOS is : c2801-ipbase-mz.124-1c.bin

Any help would be appreciated..

Thanks,

Hardik..

[jackyoung]

According to the doc. below, it requires the PLUS feature set. I believe you are using IP base only and may not able to support this module, try to upgrade to IP Plus and try again.

http://www.cisco.com/warp/public/788/products/2em_vic.html

Hope this helps.