cisco 2901 wan for DIA (Direct Internet Access) Circuit

[adeebtaqui]

Can anyone please share their knowledge regarding the additional requirement in ordering cisco voice 2901 interface for  DIA (Direct Internet Access) Circuit.

[Philip D'Ath]

Do you want BGP?  Pretty much you need to order an AX licence.

If you don't need BGP and are getting a plain DIA circuit, and don't need firewall, then the "IP Base" on a router is enough.  You will only need to configure a static default route and perhaps a bit of NAT.

[adeebtaqui]

Thanks Philip. So for DIA circuit, we dont require any additional connectivity like for ADSLetc. Is there any doc regarding this scenario.

[Philip D'Ath]

You will get a provisioning document when you order the circuit.

If you are only getting a single non-fault tolerant DIA circuit you will get a single Ethernet presentation, and a block of public IP addresses to use.