Cisco 2911 Router unable to boot up

[Sreejesh S]

     I was faced password issue after trying to recover my router password my router is not booting up to normal mode now its only show ROMMON1> mode how will rectify this.  I was tried to restart and even tried to change CONF value but not working

how can solve this

Thanks

Sreejesh S

[Richard Strnad · Accepted solution]

Hi Sreejesh,

Enter:

boot

And post the output here if its not working.

Regards

Richard

[Vignesh Rajendran Praveen]

Hi Sreejesh,

Try the below.

Step1 -

rommon>dev

Step 2 - next choose the valid storage location & execute below

rommon> dir

step 3 - execute below

rommon>boot :

Kindly follow the above steps & check if it helps.  Also kindly see to it that the confreg value is set 0x2102

Hope this helps.

***********Plz do rate this post if you found it helpful*************************

Thanks & Regards,

Vignesh R P