Cisco 2911 router using RIP not communicating with the 10.0.0.0 nework

[smegger1965]

Good Afternoon ,

I've had a Cisco 2911 router go pop and I've obtained a replacement from Ebay. I've put the config onto the router but its not communicating with the 10.0.0.0 network

[balaji.bandi]

what is other side connected

can you post

show ip route rip

show ip route vrf sis-ums rip

[Georg Pauwen]

Hello,

post a schematic drawing of your topology, as well as the full running configuration of the device that is connected to the 2911, and to with which the communication fails.

Also, 'permit ip any any' in a NAT access list is not a good idea. Change the NAT access list to:

ip access-list extended NAT
deny ip any 192.168.0.0 0.0.255.255
deny ip any 10.0.0.0 0.255.255.255
deny ip any 172.16.0.0 0.15.255.255
--> permit ip 172.16.23.0 0.0.0.255 any