Got a 3802i (18.104.22.168) and want to use it as an access-point to do site-survey.
I went through the document and got stuck in the below process
the mobility express wlc doesnt recognize itself as an ap. Can this be achieved? 3802i acting as WLC and AP servicing clients (FAQ says yes) any help is appreciated.
I also keep getting the error message
Config not synced to APs since no AP is present
I guess you are following the document Configuring Mobility Express for Site Survey using CLI
The following APs support sitesurvey capability
- AccessPoints – 3800 Series AireOS Release 22.214.171.124 and later
=> guess you need to start with an upgrade
for some reason the tftp upgrade fails saying incorrect tar file. I tried to upgrade to 8.5 and 8.8 both same problem.
when i keep the same image (8.3.102) and try to configure the master ap (using apciscoshell command from controller mode) it registers but capwap tunnel drops every 10 seconds and clients gets disconnected.