Member since ‎08-15-2011

User Statistics

  • 175 Posts
  • 4 Solutions
  • 71 Helpful votes Given
  • 28 Helpful votes Received
Recent Badges
 30 Helpful Vote
1 Accepted Solution
1 Helpful Vote
10 Helpful Vote
50 Replies
20 Replies
10 Replies
5 Replies

User Activity

Hi,I have connected 2 pairs of Cisco 9500 in a L2 etherchannel. The STP cost to the root pair 9500 is showing 1000? Is this right?I am testing this in the lab at the moment. Any ideas why the cost is showing high? The optics are 10Gbps.Regards   
Can we form eBGP neighborship b/w two peers where one peer take physical interface address of remote-peer and 2nd peer taking loopback address of remote-peer? 
Hi,We statically assign power and channels in our wifi environment. For 9130AXI, what is the maximum power we can configure on UNII1,UNII2 and UNII3 bands. A simple table, with WLC power level (1,2,3 etc) relating to Db and Mw would be very helpful f...
Hello, Is this possible to be done without an outage?A pair of cisco 9500 in stackwise virtual mode needs IOS upgrade. I cant afford an outage and I wonder what would be the best way to do it. Initially i thought, I can put the new code in standby bo...
Hello, I have a issue with tacacs after I upgraded the cisco 9500 stackwise to code 16.12.2!The router doesn't accept the tacacs password but only local password. After authenticated with local password it goes to enable mode and accepts tacacs passw...
Community Statistics
Member Since ‎08-15-2011 10:56 PM
Date Last Visited ‎11-30-2022 12:05 AM
Posts 175
Total Helpful Votes Received 28