cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Bookmark
|
Subscribe
|
2428
Views
0
Helpful
1
Replies

Cisco 3845 vs Cisco 2911 G2

anassiry2
Level 1
Level 1

Hello,

The Cisco 2911's have aggregate 1.6 Gbps towards route processor - I am trying the same specs for Cisco 3845 router? 

from http://www.cisco.com/en/US/prod/collateral/routers/ps10537/data_sheet_c78_553896.html

The EHWIC slot provides enhancements to the prior generation's high-speed WAN interface card (HWIC) slots while provide maximum investment protection by natively supporting HWICs, WAN interface cards (WICs), voice interface cards (VICs), and voice/WAN interface cards (VWICs).

• Four integrated EHWIC slots on the Cisco 2901, 2911, 2921, and 2951 allow for more flexible configurations.

• Each HWIC slot offers high-data-throughput capability:

• Up to 1.6 Gbps aggregate toward the route processor

• Up to 2 Gbps aggregate to other module slots over the MGF

Does someone help?

Thanks,

Ansari

1 Reply 1

Joseph W. Doherty
Hall of Fame
Hall of Fame

Disclaimer

The  Author of this posting offers the information contained within this  posting without consideration and with the reader's understanding that  there's no implied or expressed suitability or fitness for any purpose.  Information provided is for informational purposes only and should not  be construed as rendering professional advice of any kind. Usage of this  posting's information is solely at reader's own risk.

Liability Disclaimer

In  no event shall Author be liable for any damages whatsoever (including,  without limitation, damages for loss of use, data or profit) arising out  of the use or inability to use the posting's information even if Author  has been advised of the possibility of such damage.

Posting

Not exactly what you're seeking, but might help.

Q. Will the EtherSwitch HWICs have a different internal bandwidth when  installed in an Integrated Services Router or Generation 2, compared to  when installed in the previous generation of Ingegrated Services  Routers?

A. No. When installed in an EHWIC slot the Etherswitch HWIC will keep the  same 400Mbps FD internal connection characteristics as in an HWIC slot  of the Cisco 1800, 2800 and 3800 series

Q. What is the connection speed to the router backplane of the EtherSwitch HWICs?

A. The 4-port HWIC connects to the backplane with a maximum throughput of  100 Mbps, while the 9-port HWIC can support a maximum bandwidth of 200  Mbps. Actual performance will depend on many factors, including  performance of the hosting router, other services configured on the  hosting router, and the type of traffic stream being generated.