08-20-2014 05:58 AM - edited 03-04-2019 11:34 PM
Hi Guys,
The following commands are not working in my Catalyst3850
Router(config)# interface port-channel 1
Router(config-if)# lacp fast-switchover
Router(config-if)# lacp max-bundle 1
Router(config-if)# end
Currentely the switch have 03.02.03 SE IPBASE .
Awaiting your reply
Sony
08-20-2014 08:03 AM
What do you aim for?
LACP config only requires
#interface range g0/1-2
#channel-group 1 mode active
#interface port-channel 1
#switchport mode [access/trunk] -configure as desired
08-20-2014 09:58 PM
Hi,
Thanks for your reply.
I have 2*1G(fiber) portchannel using LACP from a third party switch to cisco 3850 - and the problem what I'm facing is when one of the link fails the port channel goes down and takes 7-8 timeouts to come up. I wanna avoid that situation.
Hope you undestand the issue.
Cordially,
Sony
08-20-2014 10:05 PM
You might want to refer to this post: https://supportforums.cisco.com/discussion/10853161/etherchannel-lacp-fast-switchover
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide