Routing

Hello I am implementing a couple of New ASR's for my (2) Core links. The ASR's will be failover's for each other using HSRP. I want to be able to monitor stats on these devices and see there are several Versions available (5, 8 & 9)I have enabled the...

Hello Everyone, I am looking for a program to monitoring WAN equiments by windows platform, can anyone help me about it? 

why we use the default route advertise  in eigrp 

I would like to ask what the best method would be to configure my cisco 877 adsl router to have multiple firewalls installed in parallel behind the cisco 877 router. I have a multiple public IP's and I wish to assign a public ip to the cisco 877 rout...

I have a two router cisco 2811 and channel is configured between them (mpls xconnect is UP). I perform the TCP test using JPerf, which occupies the entire band. The resulting bandwidth is 20 Mbit (mpls xconnect) and 15Mbit (l2tp). Can I set a limit o...

I'm trying to figure out if what I've been asked to do is even possible.Current topology for the office in question:Internet -> ISP Gateway (no control) -> MPLS Cloud -> (10.1.1.0 outside) My 2800 Router (full control) -> Local network (10.10.10.0) I...

Hi How to achieve the Below ? any configuration example? 1)How to modify the preference value of the default route to be less prefered than OSPF External route2)how to redistribute the default route as type 2 external route3)how to redistribute the d...

Hi everyone!I implemented a GRE tunnel in Nexus 7000 but the traffic was very slow at the point that it failed. Another engineer tells me that this happens because the way Nexus handles EIGRP over GRE is different from catalyst 4500 (the remote end p...

Hello,I have 28-Port Gigabit Managed Switch Cisco SG300-28. I have tried to upload the latest firmware Sx300 Firmware Version 1.4.0.88 from 15 August 2014, but got an error message during the upload that the file is too big. Could you please help me?...

HI EveryBody, I have an issue with my PFR , i receive always an alert :%%OER_MC-4-WARNING: OER does not support more than 1000 prefixes Even if i low the max prefix, the OER still present this Alert ?  

Hi All,On a VPN tunnel Interface if I have side A on a 10Mb Down / 5Mb Up connection and Side B on a 4Mb Down / 0.5Mb Up, what would be best practise on the Bandwidth command within a tunnel Interface? It was noted before that if the two VPN ends are...