cisco 3925 spe200 router rommon issue

[jkay18041]

I have a Cisco 3925 spe200 that has a password on it and I'm trying to remove it. When I try to break at bootup into rommon it shows this

Total memory size = 1024 MB - DIMM0 = 512 MB, DIMM1 = 512 MB
CISCO3925-CHASSIS with C3900-SPE200/K9 with 1048576 Kbytes of main memory
Main memory is configured to 72/72(dimm 0/1) bit mode with ECC enabled

Readonly ROMMON initialized
Booting c3900e-universalk9-mz.SPA.152-4.M7.bin ...
[BREAK]

monitor: command "boot" aborted due to user interrupt

autoboot: boot failed(boot flash0:c3900e-universalk9-mz.SPA.152-4.M7.bin), restarting...

It does this over and over. I then took out the flash card and put it in my computer and imaged it then deleted all the files off of it except the IOS image. Same thing and when it boots there is still a config. 

Any ideas on how to get rid of this autoboot and get into rommon?

Thanks

[Julio E. Moisa]

Hi

Try these steps, it should go to rommon:

http://www.cisco.com/c/en/us/support/docs/routers/2800-series-integrated-services-routers/112033-c2900-password-recovery-00.html

[Predrag Jovic]

If break does not work, try one of other key sequences - Standard Break Key Sequence Combinations During Password Recovery

If all these methods fail to properly send a break, retry the procedures from a different terminal or PC platform.