Hi,
I have a Cisco 6524ME with IOS Advanced IP services version 12.2(33)SXH4.
When the switch boots rightly, it reloads after 30 seconds that I can enter into CLI.
During this short time I execute "show diagnostic events" and the output is the following.
Diagnostic events (storage for 500 events, 1 events recorded)
Event Type (ET): I - Info, W - Warning, E - Error
Time Stamp ET [Card] Event Message
------------------ -- ------ --------------------------------------------------
06/17 16:44:48.760 E [1] TestLoopback Failed
When I execute "show interface status", no output is reported.
Every 3 or 4 reloads the system remains in rommon mode at switch processor level.
Just previously entering in rommon mode, this message is reported:
*** System received a Software forced crash ***
signal= 0x17, code= 0x24, context= 0x430252b4
PC = 0x411ac108, SP = 0x41bfc388, RA = 0x408d73b4
Cause Reg = 0x00001020, Status Reg = 0x34008002
What is the problem?
Is there any solution?
Thanks in advance
Antonio
