02-10-2010 04:33 AM - edited 03-04-2019 07:27 AM
Is there any way to SPAN(mirror) TX and RX on an Cisco 7606 router with an ES20 card (for downlink - with attached DSLAMs) .
When i try to SPAN the TX i get the following error:
- % EVC port Gi4/0/0 cannot be SPAN TX monitor source due to platform limitation
is there any way to mirror the RX+TX flow (maybe with netflow? - i don't have access to the router at the moment)
02-10-2010 06:15 AM
Hello,
be aware of SPAN limitations on ES20 :
Follow these SPAN restrictions when you configure a ES20 line card on the Cisco 7600 series router:
•SPAN is not supported on EVC ports.
•Traffic is incorrectly relayed to a local SPAN port instead of the SPAN destination port when the following conditions occur:
•When the SPAN source and SPAN destination ports belong to ports [0-9] or both ports belong to ports [10-19]
•The SPAN source port has a QoS policy-map attached and SPAN traffic matches that policy-map except for class-default.
Using ports [0-9] as SPAN source and [10-19] as SPAN destination or vice versa to avoid the above mentioned limitations.
•You cannot use Gi|Te x/0/1 as a SPAN source port when the diagnostic test TestMacNotification is enabled.
see
http://www.cisco.com/en/US/docs/routers/7600/install_config/ES20_config_guide/baldovw.html#wp1111231
So what you see reflects a known limitation.
netflow may be a way to monitor traffic
>> Sampled Netflow
sampled
Hope to help
Giuseppe
03-01-2010 06:50 PM
It looks like it's on L2 ports (trunk Dot1Q mode) so the flow-sampler can't capture the L2 traffic, it' works only on L3 ports (neither with MPLS packets)
Any idea ?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide