cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1292
Views
0
Helpful
2
Replies

Cisco 7609 - Enable Password Unable to Break.

Akhileshpk_2
Level 1
Level 1

Hi all,

Cisco 7609 Router, Enable password unable to reset.

Many times CTRL+BREAK Key combination while booting the router does not takes the console to ROMMON.

Router boots using the IOS image in the bootdisk0: (For entering into the ROMMON, removed both the external Flash disks also - no use)

2 or three time in a day it enters in to the ROMMON while pressing CTRL+BREAK.

Tried in the ROMMON (one Sup is removed) with confreg 0x2142 followed by reset/boot commands, the router is booting with the startup config.

Any work around will be appreciated.!!!

Thanks and Regards

Akhil

2 Replies 2

Akhileshpk_2
Level 1
Level 1

Hi,

This issue is resolved by pressing the ESC key while booting, which will takes you to RP mode. (Removed one RP)

Router-sp>

Router-sp>enable

Router-sp# erase nvram

Router-sp#reload

The solution may help you in the future!! 

Thanks and Regards

Akhil

Very impressive, Akhil..

What about Cisco HP Blade 3200 ?

Thanks,

KA

Review Cisco Networking for a $25 gift card