07-28-2006 09:58 AM - edited 03-03-2019 01:29 PM
I purchased a used 804 router and it appears it has not been reset to the default config and I do not have the credentials to login to the router. In my terminal session, when I connect, I am prompted for my login credentials and I can not get to a prompt to enter commands. Where do I go from here to get this reset? The only factory default setting restore procedures that I have seen require that I have to enter commands, but I can not get to a prompt to do that? I am stuck. Thanks.
07-28-2006 10:52 AM
use password recovery procedures to get the router to a prompt you can use.
see the following link for more info:
07-28-2006 03:55 PM
Thank you. I was able to follow those steps. However, what username do I use to login to the router once I have enabled the secret password? Thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide