cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
526
Views
0
Helpful
2
Replies

Cisco 804 Router - help

zoo-loo79
Level 1
Level 1

I purchased a used 804 router and it appears it has not been reset to the default config and I do not have the credentials to login to the router. In my terminal session, when I connect, I am prompted for my login credentials and I can not get to a prompt to enter commands. Where do I go from here to get this reset? The only factory default setting restore procedures that I have seen require that I have to enter commands, but I can not get to a prompt to do that? I am stuck. Thanks.

2 Replies 2

gpulos
Level 8
Level 8

use password recovery procedures to get the router to a prompt you can use.

see the following link for more info:

http://www.cisco.com/en/US/products/hw/routers/ps380/products_password_recovery09186a00800942c2.shtml

Thank you. I was able to follow those steps. However, what username do I use to login to the router once I have enabled the secret password? Thanks.