Hi everyone,
I have a Cisco 871 Adsl router (IOS C870-ADVSECURITYK9-M), Version 15.1(4)M6)
This will be connected to an adsl line for dialup to the ISP. I have used the configuration before, but for some reason I cannot get it to light up the PPP connection. Under the interface Virtual-PPP1 interface I used to have the command: pppoe-client dial-pool-number 1
But now it gives me an error when I want to configure it there.
config-if)#pppoe-client dial-pool-number 1
^
% Invalid input detected at '^' marker.
Any advice will be greatly appreciated:
version 15.1
service nagle
no service pad
service tcp-keepalives-in
service tcp-keepalives-out
service timestamps debug datetime msec localtime show-timezone
service timestamps log datetime msec localtime show-timezone
service password-encryption
service linenumber
service compress-config
service sequence-numbers
!
hostname WHATEVER
boot-start-marker
boot system flash
boot-end-marker
!
!
logging snmp-authfail
logging buffered 51200 warnings
enable secret 4 X8zyQatqYasFWjVyCf0nQwNNTGLAs9u5rn7Uq/bZ6c6
!
aaa new-model
aaa session-id common
clock timezone GMT 2 0
crypto pki token default removal timeout 0
!
!
dot11 syslog
no ip source-route
no ip gratuitous-arps
ip dhcp excluded-address 192.168.1.254
ip dhcp excluded-address 192.168.1.253
ip dhcp excluded-address 192.168.1.240
ip dhcp pool 192.168.1.0/24
network 192.168.1.0 255.255.255.0
default-router 192.168.1.254
dns-server 192.168.1.254 8.8.8.8
lease 0 2
ip cef
no ip bootp server
no ip domain lookup
ip domain name telkomsa.net
ip name-server 196.43.45.190
ip name-server 8.8.8.8
ip name-server 8.8.4.4
!
archive
log config
hidekeys
username admin privilege 15 password 7 12170003110A1E016E38212B262727
ip telnet source-interface Loopback0
ip tftp source-interface Loopback0
ip ssh time-out 60
ip ssh version 2
!
!
no crypto isakmp enable
!
interface Loopback0
no ip address
!
interface ATM0
no ip address
load-interval 30
no atm ilmi-keepalive
!
interface ATM0.1 point-to-point
pvc 8/35
!
!
interface FastEthernet0
no ip address
!
interface FastEthernet1
no ip address
!
interface FastEthernet2
no ip address
!
interface FastEthernet3
no ip address
!
interface Virtual-PPP1
ip address negotiated
ip mtu 1452
ip nat outside
ip virtual-reassembly in
ip tcp adjust-mss 1412
ppp chap hostname WHATEVER
ppp chap password 7 094A645A4616264756
ppp pap sent-username WHATEVER
no cdp enable
!
interface Vlan1
ip address 192.168.1.254 255.255.255.0
ip mtu 1452
ip dns view-group dns
ip nat inside
ip virtual-reassembly in
ip tcp adjust-mss 1412
hold-queue 100 out
!
interface Dialer0
ip address negotiated
no ip redirects
ip mtu 1492
ip flow ingress
ip nat outside
ip virtual-reassembly in
encapsulation ppp
ip tcp adjust-mss 1452
load-interval 30
dialer pool 1
dialer-group 1
ppp authentication pap callin
ppp pap sent-username WHATEVER...
ip forward-protocol nd
no ip http server
no ip http secure-server
!
ip dns view dnsfwd
dns forwarder 196.43.45.190
dns forwarding source-interface Loopback0
ip dns view-list dns
view dnsfwd 10
ip dns server
ip nat inside source list 100 interface Dialer0 overload
ip route 0.0.0.0 0.0.0.0 Virtual-PPP1
ip route 0.0.0.0 0.0.0.0 Dialer0
!
ip access-list standard VTY
ip access-list standard access
!
logging facility local6
access-list 50 permit any
access-list 100 permit ip 192.168.1.0 0.0.0.255 any
dialer-list 1 protocol ip permit
no cdp run
snmp-server ifindex persist
snmp-server queue-limit notification-host 1
snmp-server enable traps tty
!
!
!
control-plane
!
banner motd ^CC
/// CISCO \\\
NO UNAUTHORIZED ACCESS
^C
!
line con 0
session-timeout 5 output
exec-timeout 120 0
password 7 000A1612075A19034B32494D1C0B00
logging synchronous
no modem enable
transport preferred ssh
stopbits 1
line aux 0
line vty 0 4
session-timeout 10 output
access-class 50 in
exec-timeout 120 0
privilege level 15
transport preferred ssh
transport input ssh
!
scheduler max-task-time 5000
ntp server 196.4.160.4
sntp source-interface Loopback0
end
