02-07-2012 05:45 AM - edited 03-04-2019 03:10 PM
Hi,
We have just purchased a 887 router to make a site-to-site VPn between out offices. In one of them we have an ASA 5520 and we are trying to have the new 877 router working with DSL conection before trying VPN.
The point is that I am not able to connect it to DSL, I have follow several manuals an there wasn't any way to do it.
As I followed instructions I found I couldn't bring some configurations to the router, such as "dsl operating-mode auto"
Does anybody know what I am leaving on the way?
A show vesion command shows this: Cisco IOS Version 15.1(4)M3
Hardware:
1 DSL controller
1 Ethernet interface
4 FastEthernet interfaces
1 ATM interface
1 irtual Private Network (VPN) Module
256K bytes of non-volatile configuration memory
124160K bytes of ATA compactFlash (Read/write)
Device is CISCO887VA-K9
Thank you very much.
Kind regards
02-07-2012 05:58 AM
Does another modem/router work on the circuit ?
02-07-2012 06:35 AM
Thank you for the answer
No, I purchased it with the idea to connect it directly to the internet at that side. In the ASA side there is a Cisco 1841 router.
thank you
kind regards.
02-07-2012 07:30 AM
You need to know the connection parameters for your ISP.
02-07-2012 07:51 AM
I know them all, I think.
These are the data:
dynamic IP, encapsulation LLC vpi 8 vci 32
and after that I know username, password and DNS servers.
Thank you
02-07-2012 11:32 AM
Is that PPPoE ?
02-07-2012 04:52 PM
hi david,
could you post your show version output? your 877's K9 IOS should be able support the "dsl operating-mode auto" command and for your VPN.
did you try to put the said command under the ATM interface? and as paolo pointed out, is this PPPoE or PPPoA connection?
877(config)#int atm0
877(config-if)#dsl ?
enable-training-log enable the Alcatel fw training log
lom Loss Of Margin watch counter for line retrain
operating-mode auto or full rate or G.lite mode
877(config-if)#dsl operating-mode ?
ansi-dmt ANSI full rate mode
auto auto detect mode
itu-dmt ITU full rate mode
02-09-2012 03:50 AM
02-09-2012 10:41 AM
Is not said that you have to configure operating-mode, but if you have to, for an 887VA, that is done under controller vadsl, not interface.
02-11-2012 06:40 PM
hi david,
apologies i thought this setup is for an 877.
as for the 887, AFAIK i don't think the "dsl operating-mode auto" command is necessary. just put in the VPI/VCI and encapsulation type.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide