Cisco 887 change Annex A/M mode

[m.kern]

Hi,

can I change the Annex mode from A to M on an CISCO887W-GN-E-K9?

kind regards

manuel

[paolo bevilacqua]

No, it's not possible to do that.

[mavespig]

Hi Manuel,

CISCO887W-GN-E-K9 supports only annex A.

800 routers that support Annex M can be identified by a "M" in the product name, for example CISCO887MW-GN-E-K9.

An Annex M router can work on both Annex A and M, but an Annex A router can work only on A.

If a router supports both annexes, you can use the interface command "dsl operating-mode" to force a specific annex (default is auto mode).

You can refer to this document for router specifications:

http://www.cisco.com/en/US/prod/collateral/routers/ps380/data_sheet_c78_459542.html

Hope this helps

Marco