Hi,
We have a Cisco ASR1004 with SPA-8X1GE-V2 SPA. When we insert an SFP-GE-T in the SPA, the link fails to become active. The LEDs are amber in color and the interfaces status is down down. The ASR is directly connected to a Cisco 2960 switch. We have verified cables are good and ports on the switch are good as well. We have tried to set port speed/duplex, nonegoiate auto etc on both ends to no avail.
RT-HQ#show hw-module subslot 0/0 transceiver 6 idprom
IDPROM for transceiver GigabitEthernet0/0/6:
Description = SFP optics (type 3)
Transceiver Type: = GE T (26)
Product Identifier (PID) = N/A
Vendor Revision = 11
Serial Number (SN) = MTC1231008M
Vendor Name = CISCO-FINISAR
Vendor OUI (IEEE company ID) = 20.20.20 (2105376)
CLEI code = N/A
Cisco part number = N/A
Device State = Enabled.
Date code (yy/mm/dd) = 13/03/04
Connector type = LC.
Encoding = 8B10B
NRZ
Nominal bitrate = GE (1300 Mbits/s)
Minimum bit rate as % of nominal bit rate = not specified
Maximum bit rate as % of nominal bit rate = not specified
