Cisco ASR 1006 Configure Interface Speed

johnlloyd_13 · ‎03-13-2018

hi,

i can't seem to apply speed 100 on my cisco ASR 1006. i was able to configure the same speed on the same router on the other side. anything i missed?

ASR1006(config-if)#speed 100
^
% Invalid input detected at '^' marker.

ASR1006(config-if)#sp?
spanning-tree

ASR1006(config-if)#no s?      <<< WAS TRYING no switchport
sap-priority    sbc       service service-insertion
service-policy shutdown smrp     sna
snapshot        snmp      source   spanning-tree
srlg            standby

johnlloyd_13 · ‎03-13-2018

nevermind. i think there's no SFP plugged on this port.

might as well visit the site.

Leo Laohoo · ‎03-14-2018

LOL.

I don't think GLC-TX can be configured for 100 Mbps on an ASR.