Cisco ASR 920-12CZ-A is not accepting " ip nat " command under the interface

[MakTanveer]

Hello All,

I am trying to configure " ip nat inside " command under the interface but router ASR 920-12CZ-A is rejecting the command.

Please support by sharing the information if this router supports the  " NAT CONFIGURATION " or not.

logs shared below

*****(config)# int Gi0/0/0

*****(config)#description "DIA DOWNLINK"

*****(config)#ip address 10.1.1.1 255.255.255.0

*****(config)# ip nat inside

                                   ^

% Invalid input detected at '^' marker.

#sh ver

Cisco IOS XE Software, Version 03.18.00.SP.156-2.SP-ext

Cisco IOS Software, ASR920 Software (PPC_LINUX_IOSD-UNIVERSALK9_NPE-M), Version 15.6(2)SP, RELEASE SOFTWARE (fc2)

Thank you all in advance

[Georg Pauwen · Accepted solution]

Hello,

I think only the ASR920-12SZ-IM supports NAT...