cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
581
Views
0
Helpful
1
Replies

Cisco cellular profile is switching from active to inactive

kolesj85
Beginner
Beginner

Upon configuring my Cisco 887 VAG 4g router, the cellular profile was active so it is ready for failover if my DSL connection fails. The next day the profile is now showing as inactive. I have spoken to the sim provider and said everything is correct on their end and coverage is great and is not showing any dips over a 24 hour period. 

 

I am just wondering what would change the cellular profile from being active to inactive?

The 4g failover is no longer working. I reconfigured the router and it went back to being active, but it went back to inactive after a few hours. Any advice would help

 

 

Profile password Encryption level: 7


Profile 1 = ACTIVE* **
--------
PDP Type = IPv4
PDP address = ********
Access Point Name (APN) = ********
Authentication = *****
Username: *****
Password: *********
Primary DNS address = 10.4.0.0
Secondary DNS address = 10.4.0.0

* - Default profile

 

Profile password Encryption level: 7


Profile 1 = INACTIVE* **
--------
PDP Type = IPv4
Access Point Name (APN) = ********
Authentication = ********
Username: *********
Password: ******

* - Default profile
cn_2055490#sh run

1 Reply 1

Elliot Dierksen
VIP Collaborator VIP Collaborator
VIP Collaborator

Does it go inactive when there is no traffic traversing the link? How are you routing the traffic to this link when the primary path fails?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers