Hi, I'm running a CSR1000v in production. I have the advanced 100Mb license and am currently on version 3.12.0.
I have noticed some throughput issues and I finally notice that the hardware throughput level was set to 10000 kb, or 10Mb. Well, I purchased a 100Mb license so I want to make sure I used all of it I can. When I try to enter the command 'platform hardware throughput level 100', which I expect to make the throughput level 100 megabits/sec, a 'show platform hardware throughput level' still shows 10000 kilobits/sec, or 10 megabits/sec. I can change 'platform hardware throughput level 5000', and the show command shows the value of 50Mb. When I try 'platform hardware throughput level 100000' I get an error.
Any thoughts? Thanks.
