Cisco ISR 4221/K9- Configuration

[mubangaclinton]

Hello

I am trying to configure my Cisco 4221/K9 and when I enter a command in the privileged mode it say the configuration is not supported. It has a linux terminal when I click the question mark in this case to finish my command like config terminal it says this configuration is not supported.

How can I resolve this issue. I just bought a new Cisco router with the latest IOS.

[Giuseppe Larosa]

Hello mubangaclinton,

what commands are you trying to configure on your router ?

What IOS version is running on your router ?

What licenses are installed ?

post

show version

show license install all

modern routers use a licensing model quite complex, so you likely need a license to use the feature you would like to configure.

It is not anymore only a question of version.

Hope to help

Giuseppe

[mubangaclinton · Accepted solution]

Thanks.
I did some research and found out why I was failing to configure in the
privileged mode. Firstly I needed to stop PNP and since the 4000 series
router are using SDN certain commands like config-terminal are not
applicable.
Anyway thanks for your efforts. I have successfully configured what I
needed on the router.

Regards
Clinton

[Ismael_Ouattara]

Hello brother
I hope you are well. I have the concern you shared. Can you help me with the solution even if it is old I hope you can help me.
Thanks a lot.