Cisco Packet Trace route problem

[Translator]

Hello,

I'm new to network administration and currently licensed.

I have a problem with my static routes, I can't ping my router0 with the IT PC.

If I do a show ip config nothing appears on my switch core... I don't understand why, if I have already added routes (you can see them by doing a show run).

The PKT is attached.

Thank you very much for your help.

[Georg Pauwen · Accepted solution]

Hello,

on the switch, enable 'ip routing':

Switch#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#ip routing
Switch(config)#end

[Translator]

Thank you very much it works! I forgot to activate this on the switch!