03-26-2024 01:10 AM - edited 03-26-2024 01:14 AM
Hello i have cisco 1921/k9 when i first do a factory reset and configure the router the internet works until the next day then i have no internet connection. I am using cable modem connection with spectrum which is my isp.
i am using the following commands
conf t
int g0/0
ip address dhcp i obtain ip on fresh erase if i try to issue the command the router wont obtain an ip from the modem
also I would like to add that I tried to add static ip and did not work
03-26-2024 01:28 AM
Hello @arubio4 ,
Have you tried asking the ISP? Is this the ISP recommended configuration for your router?
03-26-2024 01:35 AM
I am on dynamic ip address from isp
03-26-2024 01:31 AM
debug dhcp packet <<- share this
MHM
03-26-2024 01:36 AM
Which commands should i use for that
03-26-2024 01:38 AM
debug dhcp packet
MHM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide