Routing

Bonjour,J'ai un VLAN bureautique en 192.168.1.0. Mon CBS350-8T-E-2G a l'adresse 192.168.1.240.La passerelle par défaut est le 192.168.1.1.J'ai un VLAN formation en 192.168.80.0. Mon CBS350-8T-E-2G a l'adresse 192.168.80.1, le dhcp fonctionne parfaite...

The document Cisco Nexus 9000 Series NX-OS VXLAN Configuration Guide, Release 10.2(x) - Configuring Layer 4 - Layer 7 Network Services Integration [Cisco Nexus 9000 Series Switches] - Cisco describes a scenario with a firewall connected to a VxLAN fa...

Hello i have cisco 1921/k9 when i first do a factory reset and configure  the router the internet works until the next day then i have no internet connection. I am using cable modem connection with spectrum which is my isp. i am using the following c...

Dear Expert,Hope all is well.One of cisco route 2921 reboot it unexpectedly and upon checking, we find out below result:cisco router reload reason bus error at PC 0xB0D0B0D, address 0x0.the firmware version: c2900-universalk9-mz.SPA.157-3.M8.binthank...

Hi ,how to configure snmp ver 1 or 2c in cisco n540 router.Please provide me command please.Thanks,Prashanth

Hello,I wanted to know if: Can you designate an IP address from a BVI interface as a Default Gateway to all kinds of end point devices connected to any of the interfaces belonging to the bridge group?Should it  be possible to ping that interface from...

Hello everyone,Currently seeking assistance in identifying the issue.We have two ASR 9006 routers located at two different sites. Both routers are running OSPF between them, utilizing multiple sub-interfaces, with each sub-interface assigned to a dif...

Hi ,I want apply default route in Cisco N540x router.But i am not able to find ip route command in router.Can someone help me which the comand for that.Thanks,Prashanth  

Hello,My datacenter will be move to other location, and we want to minimize the downtime. what in my mind is i will set up a new server with the network in a new location and i will migrate my virtual server one by one from old location to new locati...

Hi, We have a bunch of 2911 and 4331 (and a few 2800 left) routers in branch offices around the world. Is there a way to get these routers to log when port errors occur? Like any input/output interface errors, especially CRC/FCS? Or is the only optio...

I'm currently learning CCNA, and I've reached a section where we need to perform a password recovery for the router. However, when I power off the router and then turn it back on, I've found that the shortcuts for accessing ROM Monitor (ROMMON) mode ...

Hi! I was wondering, is there a way to set different RIP timers for each individual network advertised by a RIP router in a L3 switch or will those timers always affect all the networks equally? Thanks!

Hello Cisco Community.I hope I could make myself clear, cause my homelanguage isn' t english.I have SG350-28P and two internet connection, witch connected with Mikrotik router, witch doing NAT.My goal:Mikrotik 1 - let' s say vlan10 and 192.168.0.1/24...