Cisco Router 866VAE

[assistenzapea1]

Hello a my costumer buys the model in object. I tried to config but the interface vdsl don't come up. I hope because is that is the wrong model for the italian ADSL.

Is possible that is about this that i cannot use it?

Thanks

[Mark Malone]

Here is what is supported by this router types of dsl as well in it , you need to check that your isp is using the same on their end

http://www.cisco.com/c/en/us/products/collateral/routers/800-series-routers/data_sheet_c78-693249.html

[assistenzapea1]

Hi mark here in italy we use the ANNEX A type that is supported from the model 867VAE. My customer buy the router on amazon and when ask me what model must buy i see that is indicated ADSL and i hope that have both type on board.

I ask you if is possible convert the 866 to an 867.

Thanks for answer

[Mark Malone]

Hi i have never heard of them being converted as there specifically designed for certain types as below , 887 use annex a and m , 886 uses annex b

Model	DSL Technology	Minimum Cisco IOS Software Release Requirement
Cisco 867	Asymmetric DSL 2 (ADSL2) and ADSL2+ over basic telephone service (Annex A)	12.4(22)YB3 or 15.0(1)M
Cisco 886	ADSL2/2+ over ISDN (Annex B)	12.4(22)YB3 or 15.0(1)M
Cisco 866VAE	Cisco 866VAE router with VDSL2/ADSL2+ over ISDN	15.2.(2)T or 15.1(4)M2
Cisco 867VAE	Cisco 867VAE router with VDSL2/ADSL2+ over POTS	15.2.(2)T or 15.1(4)M2
Cisco 886VA	Multimode VDSL2 and ADSL2 and 2+ over ISDN	15.1(2)T
C886VAG	Multi-Mode VDSL2/ADSL2+ over ISDN	15.1(4)M
Cisco 887	ADSL2/2+ over POTS (Annex A)	12.4(22)YB3 or 15.0(1)M
Cisco 887M	ADSL2/2+ over POTS (Annex M)	12.4(22)YB3 or 15.0(1)M
Cisco 887V	Very-high-bit-rate DSL 2 (VDSL2) over POTS	12.4(22)YB1, 12.4(24)T, or 15.0(1)M
Cisco 887VW, Cisco 887VG, and Cisco 887VGW	VDSL2 over POTS, with 802.11n and 3G	15.0(1)M

[assistenzapea1]

ok i hope that my customer must return it to amazon and change with right model.

Thanks a lot for your support

[Mark Malone]

No problem just mark the post correct if it has answered your query thanks