cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
774
Views
0
Helpful
4
Replies

Cisco router connected to Juniper firewall

tonynsx
Level 1
Level 1

I have a Cisco 2911 router and a Juniper SRX550. The Cisco 2911 is directly connected to the Juniper SRX550. I can ping both networks from either routers.

When I connect to https://172.16.128.1 from the Juniper SRX550, I'm able to login from the web gui.

enter image description here

enter image description here

But, when I go to https://172.16.128.1 from the Cisco router, get the "Your connection is not private page" just like on the SRX550, but then I get this.

enter image description here

What could be the reason for this?

4 Replies 4

Hello

From the Cisco router
telnet 192.16.128.1 443
telnet 192.16.128.1 443 /source-interface "juniper interface"

what results do you get...


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

I'll check the router tomorrow.  Thanks for your help.

Trying 172.16.128.1, 443 ... Open

[Connection to 172.16.128.1 closed by foreign host]

Hello

So from the Cisco router you can access the web site, now as the Cisco and juniper are directly connected which one of the two are closest to the web server.

Can you perform the same test sourcing from another interface on the Cisco rtr, either from the interface that attaches to the juniper or a lan interface, Also have you tried using a different web browser 

 

telnet 192.16.128.1 443 /source-interface xxxx



Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul
Review Cisco Networking for a $25 gift card