12-14-2019 01:22 PM
Hi there,
How do i connect to a SG300-10 to do configuration?
I try http using the default ip, but i can not connect.
How do i connect to the switch physically? By using a straight network cable? Directly to one of the port?
Regards,
rsd16
12-16-2019 02:29 AM
Hello,
not sure what you have already tried, but have a look at the guide below. You need a straight (regular) Ethernet cable.
12-16-2019 07:44 AM
Hello,
I have one of these and rather than using a traditional baby blue console cable they use a serial cable, connecting is pretty much identical but you will need to adjust the baud rate to 115200.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide