Cisco Switch SG220-50P with no "service" command

[Jordan023]

Have a cisco 2960 x-series switch that I am about to retire. I do not have a spare of such model but would like to copy configs to the SG220 switch. I hit wall in the Global Configuration when the SG220 could not accept the

 "service" 

command.

For example: Trying to paste this command in (below)

no service pad
service tcp-keepalives-in
service tcp-keepalives-out
service timestamps debug datetime msec localtime
service timestamps log datetime msec localtime

Output:

Switch40B404(config)#no service pad
es-in
seUnknown command
Switch40B404(config)#rvice tcp-keepalives-out
service timestamps debug datetime msec localtime
service timestamps log datetime msec localtimeservice tcp-keepalives-in
Unknown command
Switch40B404(config)#service tcp-keepalives-out
Unknown command
Switch40B404(config)#service timestamps debug datetime msec localtime
Unknown command
Switch40B404(config)#service timestamps log datetime msec localtime

How can I solve this?

Kindly assist.

[marce1000 · Accepted solution]

  - sg220 does not run IOS , you need to look at administrative guide(s) for equivalent command(s) , if available.

 M.

[Jordan023]

Thank you. Spent awhile trying to figure it out.