Dear all,
I have a Cisco 3660 router with Serial4T card and need to config E1 on these ports. Please help with the config. Thank you very much.
Duc Vu
P.S. Here is router's info:
interface Serial3/0
no ip address
shutdown
Serial3/0 is administratively down, line protocol is down
Hardware is QUICC Serial
MTU 1500 bytes, BW 2048 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation HDLC, loopback not set
Keepalive set (10 sec)
Mueslix-4T Port adapter, 4 ports
Port adapter is disabled deactivated
Port adapter insertion time unknown
EEPROM contents at hardware discovery:
Hardware revision 1.1 Board revision D0
Serial number 14440376 Part number 800-02314-02
FRU Part Number: NM-4T=
Test history 0x0 RMA number 00-00-00
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 54 01 01 00 DC 57 B8 50 09 0A 02 00 00 00 00
0x30: 68 00 00 00 99 05 17 00 00 05 FF FF FF FF FF FF