Configure FTP on Port 990

[jjcomp]

I currently have a Cisco 891 running with a FTP running on port 21. I currently have the NAT from external IP to and internal IP 192.168.12.6 for port 21. And the firewall allowing that traffic through and client software is working fine. However I need this FTP to be running on port 990 and anytime I change the NAT and the firewall, the external FTP clients connect but then drop when recieving the directory listing.

Any help would be greatly appreciated!

Sent from Cisco Technical Support iPad App

[jjcomp]

I forgot to ask, is the inspection of FTP setup as needed?

Thanks Again!

Sent from Cisco Technical Support iPad App

[jjcomp]

Jennifer,

Tried it...  As soon as I set the access lists to external ip of fa8, I was not even able to get the connection to go through.

This was also none with the port-map and same results.

Any other thoughts....  Again, any help is appreciated....

[Jennifer Halim]

Can you try to port map it to port higher than 1024? 990 is a well known port for sftp.

Try 9990 and see if it works.

[jjcomp]

Jennifer,

Sorry, but that didn't work either....  I have also tried port 2021, no luck.

Anyother ideas?