Configure IP SLA on WS-C6509-E

[Tony T.]

Hello-

Can I configure IP SLA on a 6509 w/ IOS 12.2(18) SXF7? When attempting to configure IP SLA on the CLI I don't see an option. I even looked for the legacy command "rtr" and didn't see that either. Any assistance is appreciated.

Kind Regards,

Tony 

[balaji.bandi]

it should support, can you post show version complete ?  what is supervisor is this ?

what is the config error you get when you enter the command ?

here is feature navigator

https://cfnng.cisco.com/archived-data

[Tony T.]

Hey balaji,

(Forgive me if that's not your first name.)

So the first thing, I can't find the specific platform I'm asking about (WS-C6509-E) in that link (https://cfnng.cisco.com/archived-data)

The second thing is I can't provide a complete view of the "show version" command. However, I copied as much as I could.

Cisco Internetwork Operating System Software
IOS (tm) s72033_rp Software (s72033_rp-ADVIPSERVICESK9-WAN-M), Version 12.2(18)SFX7, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-206 by Cisco Systems, Inc.
Compiled

ROM: System Bootstrap, Version 12.2(17r)SRE, RELEASE SOFTWARE (fc1)
BOOTLDR: Cisco IOS Software, s72033_rp Software (s72033_rp-ADVIPSERVICESK9-WAN-M), Version 12.2(18)SFX7, RELEASE SOFTWARE (fc1)

Cisco WS-C6509-e (R7000) processor (revision 1.2) with 1900000K/131072K bytes of memory.
Processor board ID **********
SR71000 CPU
SuperLAT Software
X.25 Software, Version 3.0.0
Bridging Software

Lastly, there is no error. The command just doesn't show up.

Tony

[balaji.bandi]

i am thinking you have Sup 720 ?

i attached data for that version of code.

post the below output :

config t

!

ip ?

[Tony T.]

Hey,

Yes, the supervisor you mentioned above is correct - WS-SUP720-3BXL.

The data you attached is great. And, the I figured out how to find that platform on the Cisco Feature site.

Nonetheless, the router does not show IP SLA. I can't show the results of the router but when I do the following command I don't see an option for IP SLA:

Router (config)# ip ?

[balaji.bandi]

i am afraid i do not have any device that has 12.X code i can test, i am sure or remember i used it.