I am trying to configure multiple dsl-groups on a HWIC-4SDHSL-E module and the option does not exist. According to the Cisco documentation I should be able to do this, but I only get pairs as an option.
1921(config-controller)#dsl-group ?
pairs Link number
<cr>
http://www.cisco.com/en/US/docs/routers/access/interfaces/software/feature/guide/GSHDSL_EFM_HWICS.pdf
This is what I am trying to do which I have done before on the 1841.
dsl-group 0 pairs 0, 1
shdsl annex A-B
shdsl rate 4096
!
dsl-group 1 pairs 2, 3
shdsl annex A-B
shdsl rate
Is it because this is only a EFM HWIC and not an EA HWIC? Then the documentation is wrong.
Any help would be appreciated.
