02-20-2007 12:52 PM - edited 03-03-2019 03:50 PM
I have a 2821 with a VWIC2-2MFT1-T1/E1 module installed in HWIC slot1, a WIC 1DSUT1 in HWIC slots 0 and 2. I am trying to configure the VWIC2-2MFT1-T1/E1 module for MLPPP connection. The command "card type t1 0" was issued and accepted by the router but I don't see the VWIC2 when I do a ?sh ip int br.? Therefore, I am having a hard time configuring the two interfaces on the VWIC. Any suggestions as to what I should do to resolve the issue?
Please see the screen capture from "sh diag" in the attachment.
Solved! Go to Solution.
02-20-2007 03:11 PM
The 'card type' command would make the router aware of the card in the slot. This can be verified by doing a 'show diag' from the privilege exec mode. To configure the serial interface you would need to configure the controller first.
Have a look at this link for configuring the controller;
HTH
Sundar
02-21-2007 11:28 AM
define controllers too... use this command or something similar, then you will see the serial interfaces in sh ip int bri command output.
controller T1 0/0
framing sf
linecode b8zs
channel-group 0 timeslots 1-24
02-20-2007 03:03 PM
Can you give me IOS name.
Regards,
Dharmesh Purohit
02-20-2007 03:11 PM
The 'card type' command would make the router aware of the card in the slot. This can be verified by doing a 'show diag' from the privilege exec mode. To configure the serial interface you would need to configure the controller first.
Have a look at this link for configuring the controller;
HTH
Sundar
02-21-2007 06:53 AM
The IOS version that is on the router is C2800NM-SPsSERVICESK9-M, Version 12.4(3a)
02-21-2007 11:28 AM
define controllers too... use this command or something similar, then you will see the serial interfaces in sh ip int bri command output.
controller T1 0/0
framing sf
linecode b8zs
channel-group 0 timeslots 1-24
02-26-2007 10:21 AM
Removed
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide