Routing

Hello,I have problems with PAT translation to a inside server. Somebody tell my that i can`t use a dynamic DHCP of the ISP to use the NAT/PAT transalation. If i configure a static ip-adres on the BVI interface then en can`t ping the ISP gateway. Is i...

no atm ilmi-keepalive.....mean? This is on the atm interface of the ADSL Router. Its a 877W ADSL Router.

HiIf fastethernet is flapping frequently then what could be the issue...? how to fix it.Please help meThanks

Hi everybody,I have a Cisco 7507 chassis with two RSP4+ processors running 12.3(18) image. Is it possible to swap active/slave processor issuing a CLI command? Otherwise how can I force this swap?RegardsStefano

HiI have no idea about Cisco WAE 512. pls can anyone simply explain of it. it is module or device , what i get benefit from it ??Thnaksbiplob

Hello,I have a cisco 2620 and a 4nm async/sync acting as frame relay switch. I have the connections setup but what I'd like to do is set the switch (router) up to send fecn/becns once the traffic reaches a certain limit. Basically I want to set the C...

First let me start by saying I'm in no way an expert in this field. We have a 7206 router that continues to increment input errors, crc errors, line errors, etc. We have worked with our DS3 provider and they can't see any errors. They have monitored ...

Hello,I have some module's name to check.From some LS1010, I have the shart-number (from the sh hardware).Can someone give me a link or a file to get the name of the module ?ex: 73-1496-03 for WAI-OC3-4MM I guessI have others part number to find l...

HiUnbalanced E1 card support 1700/1800 series router ??ThanksBiplob

does anyone knows of a good router/switch simulation which i can use to practice bgp and mpls, please let me know. thanks

Hi,I have a Internet Connection with ISDN Backup.On the primary Link I have a GRE Tunnel to a Cisco 3662, which also terminates the ISDN BAckup in case of primary Link failure..The customer have a IPSec Tunnel to 2 remote offices. The VPN to the Linu...

I have a 2600(ISP1) router which is connected to Fa1 of 2948G and a 3600(ISP2) connected to Fa2 of 2948G. The port Gig49 is connected to 3500 switch (group 1 for ISP1) and Gig50 to another 3500 switch (group 2 for ISP2). The first thing that I did wa...

Hi Sir,I have the following OSPF config:!int loopback 0 ip addr 172.16.1.1 255.255.255.0!router ospf 1 netw 172.16.1.1 0.0.0.0 area 0!OSPF advertises the loopback as 172.16.1.1/32. To advertise the subnet (i.e. 172.16.1.0/24), I'd configure:!int lo0 ...