Connecting router on a ppp multilink routers

[jigsing]

Hi everyone,

i'm new to this, i would appreciate any help. thanks

i cannot ping R23 using R22

R21 Config:

R22 Config

:

R23 Config:

Topology

[Georg Pauwen · Accepted solution]

Hello,

how is RIPv2 configured on R22 ?

[jigsing]

Thanks for the help, the problem seems to be that i forgot to create a rip on R22 thanks bro

[Michael.downing · Accepted solution]

Hello Jigsing

check your Serial interfaces. Clock rate is only required on one end. Read up on DCE / DTE

On R21 and R23 I can see RIP is configured. On R22 however there is no shown RIP configuration, and it looks like there isnt any. No shown Static Routes either. I suspect that you dont have routing in place for the ping to work. Nor the Correct Serial interface configuration. 

Check pings are successful between each device to isolate issue locations. 

Best Regards

Michael