04-14-2015 03:52 PM - edited 03-05-2019 01:14 AM
Hi All
Here is a question. There are a lot document talking about configuration in dense mode and sparse mode connection between routers. But they do not mention configuration of first router interface connecting to Video server. Do you think we just add ip pin dense-mode or ip pin sparse-mode as other interfaces ? Thank you
Solved! Go to Solution.
04-14-2015 04:08 PM
All interfaces that you want to route the multicast stream over need PIM enabled.
So if you didn't enable it on the router interface connecting to the source of the multicast stream it wouldn't work.
You also need "Ip multicast-routing" enabled on all routers that are going to route the multicast stream.
Jon
04-14-2015 04:08 PM
All interfaces that you want to route the multicast stream over need PIM enabled.
So if you didn't enable it on the router interface connecting to the source of the multicast stream it wouldn't work.
You also need "Ip multicast-routing" enabled on all routers that are going to route the multicast stream.
Jon
04-14-2015 04:31 PM
Thank you! Jon
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: