08-04-2021 10:36 AM
Currently we have a subnet setup that is not routed. All units just talk to each other inside the Vlan and everything is fine. Now the user needs the vlan routed ONLY to a specific destination that is at another location. Basically they want
10.2.2.0 /24 to only talk to 10.50.0.0 /24 However to get that it has to go through our network to get there and back. Is this possible with a route-map or ACL?
Thanks
08-04-2021 11:50 AM
We do not know much about your environment and if we knew more we might be able to give better advice. But based on what little we do know I would suggest that some sort of tunneling solution (GRE, etc) might allow your subnet 10.2.2.0 to communicate with 10.50.0.0 and not anything else.
08-04-2021 12:06 PM
Hello,
what exactly do you mean by:
--> However to get that it has to go through our network to get there and back.
?
What is the traffic flow supposed to look like ?
That said, a simple ACL would look like this:
access-list 101 permit ip 10.2.2.0 0.0.0.255 10.50.0.0 0.0.0.255
08-04-2021 12:44 PM
@Richard Burts said correctly we need to know more information about the device model. IOS code running, how is your network. given short information, we can suggest few lines of ACL, which could lead to something else.
some cookbook ACL :
https://www.cisco.com/c/en/us/support/docs/ip/access-lists/26448-ACLsamples.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide