We installed two NM-1-T3/E3 cards in our 3845 router today and we've reloaded the router twice.rebooted.
We cannot activate one of the cards with the "card" command:
border1(config)#card type t3 3
border1(config)#card type t3 2
Card in slot 2 was removed or does not support command.
Show inventory and show diag do see both cards:
ccf-border1#show inv
NAME: "3845 chassis", DESCR: "3845 chassis"
PID: CISCO3845 , VID: V01 , SN: FTX0926A5QU
NAME: "c3845 Motherboard with Gigabit Ethernet on Slot 0", DESCR: "c3845 Motherboard with
Gigabit Ethernet"
PID: CISCO3845-MB , VID: V01 , SN: FOC090600UG
NAME: "Gigabit Ethernet Controller on Slot 1", DESCR: "Gigabit Ethernet Controller"
PID: NM-1GE , VID: V01 , SN: FOC102246GP
NAME: "Clear/Subrate T3/E3 WAN on Slot 2", DESCR: "Clear/Subrate T3/E3 WAN"
PID: NM-1T3/E3= , VID: 1.0, SN: FOC09482FPF
NAME: "Clear/Subrate T3/E3 WAN on Slot 3", DESCR: "Clear/Subrate T3/E3 WAN"
PID: NM-1T3/E3= , VID: 1.0, SN: JAD0722029L
SW Version:
#show ver
Cisco IOS Software, 3800 Software (C3845-ENTSERVICESK9-M), Version 12.4(24)T3, RELEASE
SOFTWARE (fc2)
Technical Support:
http://www.cisco.com/techsupport
Copyright (c) 1986-2010 by Cisco Systems, Inc.
Compiled Tue 23-Mar-10 11:22 by prod_rel_team
ROM: System Bootstrap, Version 12.4(13r)T5, RELEASE SOFTWARE (fc1)
Do we have a dead card?
