Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Our ASA5550 was croaking last night and eventually I figured out it was getting blasted by UDP SIP packets: From IP To IP1186 09:51:09.670894 58.61.157.139 149.137.1.150 SIP Request: RE...
We installed two NM-1-T3/E3 cards in our 3845 router today and we've reloaded the router twice.rebooted.We cannot activate one of the cards with the "card" command:border1(config)#card type t3 3border1(config)#card type t3 2Card in slot 2 was removed...
Were we sold the wrong product? We installed 2 NM-1A-T3/E3 cards in our 3845, upgraded to c3845-entservicesk9-mz.124-24.T3.bin, but the interfaces show up as ATMX/0 instead of serialX/0.We need to set up frame relay encapsulation. I can't find ay exa...
I've run out of room for two IOSes on the puny 64MB CF card that came with our 3845. Couldn't find any info on cisco.com about upgrading flash:/, so I have several larger CF cards lying around and I assume they will work after I put them in the route...
We have a fairly large legacy installation of Catalyst 3500s interconnected with 62.5 MMF. Most of the links more than 200m or so have these old Allied Telesyn EX-1002 "range extenders" which are alleged to be able to run up to 2km over MMF without t...
Hate to bump an old thread, but this is the top Google search for this error. FWIW we did not start seeing this until we upgraded from c3845-ipbasek9-mz.124-22.T.bin to c3845-entservicesk9-mz.124-24.T3.bin.Setting the PuTTY rekey interval to 0 (disab...
Thanks, I suspected this after doing some searching around. We were given the impression that the "NM-1A-T3/E3" simply superceded the "NM-1-T3/E3", which does not seem to be available anymore. What happens when you let big computer vendors sell Cisco...
At the risk of bumping this topic too late, thanks for all the replies.We have got everything working, but have not yet bought any mode conditioning cables. It seems to be cheaper for me to fiddle around with randomly swapping GBICs and patch cables,...
Thanks to all who replied/ The old "SanDisk Ultra II" card from my old dead digital camera works perfectly.The CF card was swapped out with the router active, but no one logged in, then reformatted. The manual exhorts one to shut down all "network co...
