Defaulting a 2950 or 3550 Switch
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-18-2006 06:38 AM - edited 03-03-2019 02:23 PM
Is there a way/command to bring the switch back to it's factory default programming? I have a set of switches I would like to start over from scratch with. Would a startup config and vlan.dat from a new switch be all I need to completely start over, or would I still be missing something?
Thanks,
Adam
- Labels:
-
LAN Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-18-2006 07:02 AM
To rease the config-
'write erase'
To also remove the vlans-
'del flash:vlan.dat'
Then reload
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-18-2006 09:29 AM
Thanks a bunch!!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-18-2006 01:09 PM
Glad to help and don't forget to rate!
