Design Network config
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-17-2009 11:04 AM - edited 03-04-2019 03:36 AM
Hi,
We have starting a new network setup for our site can any one suggest me how i can deploy the following points on my network
1. I am planning to deploy the STP between access and distribution
2. Running HSRP between two 6500 switch like for some VLAN Switch A will be the primary and other VLAN switch B will be primary
3. In the core connecting to our two site has the two redunant fibre
can any one help me in example config for the attached network diagram
- Labels:
-
Other Routing
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-17-2009 11:05 AM
Hi,
We have starting a new network setup for our site can any one suggest me how i can deploy the following points on my network
1. I am planning to deploy the STP between access and distribution
2. Running HSRP between two 6500 switch like for some VLAN Switch A will be the primary and other VLAN switch B will be primary
3. In the core connecting to our two site has the two redunant fibre
can any one help me in example config for the attached network diagram
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-17-2009 11:09 AM
I have setup many networks like this. Take a look at www.techsnips.com and see if you can get some ideas.
www.techsnips.com
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-17-2009 11:48 AM
Hi,
I would use L3 between the core switches and the WAN switches and use a routing protocol.
In regards to core to access-layer, i might do what is attached.
rgds,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-17-2009 11:40 AM
Hi,
Cisco recommends a complete layer-3 Network design between CORE and Distribution including the access layer.
The Complete Layer-3 design has the benifit of the following:
1- Rapid link failure detection.
2- Rapid route Convergence.
You can even implement (BFD) Bidirectional forwarding detection with OSPF or EIGRP.
Pls have a look at the attached documents:
HTH
Mohamed
