- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-04-2024 04:47 PM
I attached my Packet Tracer file for review. It would only attach as a zip file. Can someone tell me why DHCP is not working on PC-A and PC-B? I receive the error: DHCP failed. APIPA is being used. I used the show ip dhcp pool command. I triple checked my router configurations, but I think I am missing configuration(s). I am using Packet Tracer 8.2.2
Solved! Go to Solution.
- Labels:
-
Other Routers
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-04-2024 07:38 PM
@rfine01 hello, your R1 interface configured wrongly. assessment need to configure R1 gi 0/0/0 with sub interfaces. you configured Gi 0/0/1 which is wrong. reconfigure interface with Gi 0/0/0 and sub interfaces.
Good luck
KB
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-04-2024 07:38 PM
@rfine01 hello, your R1 interface configured wrongly. assessment need to configure R1 gi 0/0/0 with sub interfaces. you configured Gi 0/0/1 which is wrong. reconfigure interface with Gi 0/0/0 and sub interfaces.
Good luck
KB
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-05-2024 12:27 AM
Thank you very much!! That was the issue.
